Heat Pump Repair in Parker, CO
A heat pump not heating is the call most Parker homeowners make between November and March. Sometimes the fix is a thermostat setting. Other times the outdoor unit has stopped moving heat at all and the backup strips are carrying the house. If the rooms keep dropping after a few simple checks, call and a local heat pump technician can talk it through with you.
Call (303) 647‑3227 →Related Help
Common Causes
A heat pump not heating usually has a broken link somewhere. The unit pulls heat out of the outdoor air and pumps it inside. When any link in that chain breaks, the indoor fan may still blow, so the system sounds normal while the house cools down. These four causes come up most often, and the wider list of heat pump problems covers the rest.
✓
The thermostat is in the wrong mode. A thermostat set to Cool, Off or Fan, or one with a dead battery, will never call for heat. A new thermostat with the wrong O/B setting can run the heat pump in cooling when you ask for heat.
✓
The outdoor unit is not running. A failed run capacitor, a worn contactor or a tripped breaker can stop the compressor and outdoor fan while the indoor blower keeps going.
✓
The refrigerant charge is low. A slow leak leaves too little refrigerant to carry heat indoors. The system runs longer and longer and the air at the vents feels lukewarm at most.
✓
The reversing valve is stuck. If the valve that switches between heating and cooling hangs in the cooling position, the heat pump pushes heat outside instead of in.
In Parker
Parker sits high and dry, and that changes how a heat pump behaves. Thinner air means the outdoor coil moves less air mass, so it has less heat to collect on a frigid night. During a cold snap well below zero, many older units lean hard on their electric backup strips. Some loss of output on the coldest nights is normal. A house that will not warm up on a mild day is not.
Do not keep turning the thermostat higher to force more heat. That only brings on the backup strips sooner and runs up the bill. Do not open the outdoor cabinet, bang on the unit or try to clear ice with hot water. If you smell burning or the breaker trips again after one reset, switch the system off at the thermostat and the breaker.
It becomes urgent when indoor temperatures keep falling overnight, when pipes on outside walls are at risk, or when someone in the home is very young, elderly or unwell. Setting the thermostat to Emergency Heat can hold the house while you wait, if your system has backup strips. Our page on urgent heat pump repair covers what to do next.
Call (303) 647‑3227 →
Before You Call
01
Set it to Heat, raise the setpoint a few degrees above room temperature and replace the batteries if the screen is dim or blank.
02
A filter packed with dust chokes airflow across the indoor coil. Swap it for a clean one of the same size and watch whether vent air improves.
03
From a short distance, see whether the fan spins and the unit is clear of drifted snow. If a breaker is tripped, reset it once only.
Checks did not fix it? Talk to a local heat pump technician.
Call (303) 647‑3227 →Service Areas
We take calls from homes all over Parker, from The Pinery and Stonegate to Stroh Ranch and Idyllwilde, plus nearby Castle Rock, Lone Tree and Elizabeth. A local technician who works in your part of Douglas County can come out to look at the system.
FAQ
Usually the indoor blower works while the outdoor unit does not. A failed capacitor, a contactor that will not close, low refrigerant or a stuck reversing valve are the usual suspects. The technician can test each one. Avoid opening the outdoor panel yourself because parts inside hold a charge.
Every heat pump loses output as the outdoor temperature drops, and Parker’s altitude makes that drop sharper. Older units rely on backup strips on the coldest nights. Newer cold climate models hold output much lower. If yours cannot keep up on a mild day, something is wrong.
Emergency Heat shuts off the outdoor unit and runs only the backup heat. It is a good way to keep the house warm while you wait for help if the outdoor unit is iced solid or making a bad noise. It uses far more electricity, so treat it as temporary.
Yes. A clogged filter cuts airflow, which drives head pressure up in heating mode. Many systems then trip a high pressure switch and shut the compressor off. Changing the filter is the first thing to try.
It can be. If indoor temperatures are dropping toward the fifties, if pipes could freeze or if someone at home is vulnerable, treat it as urgent and call. You can call on a weeknight or a weekend, and whether a technician can come out after hours depends on availability that night.
Most no-heat calls end with a repair, such as a capacitor, contactor, sensor or thermostat fix. Replacement comes up when the compressor fails on an older unit. The technician can explain the options and the factors, like age and refrigerant type, before any work starts.
Get Connected
A heat pump not heating only falls further behind when the next cold front arrives. Call us and a local technician who works on heat pumps in Parker can talk through what is happening. Call (303) 647-3227.
Call (303) 647‑3227 →